Tightening torque

The setting of the tightening torque changes very little over the years. Once set, it basically holds the setting year after year after year. Measurements of the setting and its deviation has been found to be as small as a few percent (at most) even after a ten-year period. Regardless, for optimal and safe usage, the torque value setting shall be checked regularly. Our recommended tool to do this regular check is to use the Ronning torque meter type.

• Torque wrench - M131-416-007
  
• Mechanical Torque meter - M103-121-00

Inspection using this type of torque meter (M131-416-007 as shown in the photograph here) requires a great deal of skill if the result is to be correct.

Follow these three simple steps for correct maintenance and setting:

1. The speed is of great significance. When tightening a valve at too low speed, it is possible to overturn a new valve by as much as half a rotation without exceeding the recommended torque setting.

2. Overtightening with about 45°, results in an increased force from about 20 to 100 Nm.

3. The torque wrench must always be perpendicular to the gas cylinder. If canted, the resulting error can be about 20 Nm.

Need support with safe and accurate valve tightening?

Correct torque settings are essential for safe and reliable gas cylinder maintenance. At L. Rönning, we offer equipment that helps you work accurately and efficiently.

Please do not hesitate to contact us. We are happy to discuss your needs and help you find the right solution.

Phone:
+46 431 45 45 03

Email:
info@lronning.com