Skip to content
Marking tool for gas cylinders

Stamp holder - Marking tool – M132-000

Will automatically hold the punch perpendicular to the surface of the gas cylinder. This results in a better impression. For example, an "8" will never become a "3".

The hand is protected the whole time against blows and vibration.

The fingers are always at least 5 cm from the punch.

As the fingers are always far from the punch, there is no risk in using greater force, and one hammer blow is sufficient even for punches with 2 digits, such as "12" for the month and "90" for the year. This means that no more than three hammer blows are required for each cylinder that is pressure tested.

Accidental turning or movement of the handle at the instant before the impact of the hammer is unimportant – the punch does not move.

  • Supplied in a set of 3 units.
  • The stamp holder is available for the following stamp sizes: 8x8, 10x10, 12x12, 14x14, or 16x16 mm (for quadrangular punches only).
  • Minimum length of stamp: 75 mm.
.price.productitem__price { display: none; }